User Interface (UI)
T2-C User Guide 77
Maintenance menu
Wipe Printhead Button
The maintenance module performs printhead wiping 3 times to clean the surface of the
printhead.
Light Clean Button
Additional maintenance routine for fixing fine streaks and for cleaning the printhead
surface. Takes about a minute. Can be run multiple times. Advised to use when automatic
maintenance routines and ink circulations are not enough.
Medium Clean Button
Additional maintenance routine for fixing streaks, spitting ink through the nozzles and for
cleaning the printhead surface. Takes about 2-3 minutes. Heavier form of Light Clean.
Advised to use when automatic maintenance routines, ink circulations and Light Cleanings
are not enough to recover print quality. Usually when medium clean is needed, it is the sign
of the particular printhead is getting aged and near the end of life.
Heavy Clean Button
Additional maintenance routine for fixing serious streaks and printhead nozzle dehydration.
Heavy cleaning takes about 5 minutes. Only advised to use when Medium clean does not
prove to be enough to recover print quality. Heavy cleaning creates a significant amount of
waste ink. Usually when heavy cleaning is needed, it is a sign that the installed printhead
has reached end of life or the printhead nozzles are heavily dehydrated.
Release Printhead Button
Opens the printhead latch to be able to install/replace the printhead physically.
To Next Page
Loading...
Need help?
General