Trojan T2-C - T2-C Threading Label Material from Scratch

Loading the label material
T2-C User Guide 31
Threading the label material from scratch
1 Press the Release Web button in the TrojanTwo tab > Handling menu.
2 Make sure that the NIP clamp is in the open position.
3 Place the chosen label material roll on the unwinder shaft. See “Rolling direction unwinder
- Ink jet coating on the inside or outside” on page 29.
4 Press the Reset Sidesteer Position button in the TrojanTwo tab > Handling menu to set
the unwinder core horizontal position to the default position.