Trojan T2-C User Manual

T2-C User Guide 93
13
Using the built in slitter for the
T2-C press
Purpose
The T2-C press has a built in, in-line slitter that works perfectly with die cut label material. Slit
up to four (4) rolls, with the three (3) easy to replace oscillating blades that ensure long life time
and perfect cuts. The blades can be placed in any position or moved to the side when not in use.
Usage
Important: The built in slitter blades can only be used with pre-diecut label material. Therefore
the slitter can only be enabled if TOF mode is set to diecut in the TrojanTwo tab > Media
Settings menu.
1 Thread the diecut label roll throughout the web path of the T2-C press. See “Loading the
label material” on page 29.
2 Load matching cardboard paper cores onto the rewinder shaft according to how many rolls
are to be slit (max. 4).
3 Open the back lid all the way up on the T2-C press to gain access to the slitter blades.

Trojan T2-C Specifications

General

Brand	Trojan
Model	T2-C
Category	Label Maker
Language	English