User Interface (UI)
72 T2-C User Guide
Shutdown
• Shuts down the T2-C press completely.
When shutting down the unit it is advised to wait with turning the power switch off until the
shutdown process is finished. There is a message on the display when the shutdown
process is initiated to indicate that the shutdown process is still going on.
When the shutdown process is finished (the screen turns blank) it is advised to turn the
physical power switch off. The power switch is located at the back of the TrojanTwo press.
Caution: Always wait until the shutdown process finishes before shutting down the power
supply! Otherwise the maintenance module inside the machine might end up in the wrong
position and cannot protect the printhead from dehydration. Dehydration of nozzles in the
printhead may result in print quality defects. The shutdown process may take 1-2 minutes.
Exporting statistics data to a CSV file / viewing statistics from
a browser
Statistics data from the HOME > Statistics menu can be exported and saved into a CSV file
from a user PC which is connected to the same network as the T2-C press.
• Actual IP address of the T2-C press can be set or acquired in the HOME > Settings >
Network menu. See “Settings menu” on page 63.
Note: The IP address shown above is an example only. The actual IP address is local
network dependent and can always be checked in the HOME > Settings > Network menu.
To Next Page
Loading...
Need help?
General