Maintenance
T2-C User Guide 101
Replacing the wiper roller
The wiper roller (microfiber roller) is a consumable and a wear part. It needs to be replaced
when it wears down.
It is advised to change the wiper roller at least after every 6 months.
The wiper roller may need to be replaced in the following situations:
• If the surface of the wiper roller looks shiny and not 'fluffy' anymore, then the wiper roller is
worn down and needs replacement.
• If the printhead wiping routines (like wipe printhead or light/medium/heavy clean) do not
improve print quality and fine streak(s) remain on the printouts after the routines have been
run multiple times.
• If ink puddles remain on the printhead surface after a wipe printhead maintenance.
Required equipment:
• Rubber gloves
• Distilled water
• Lint-free cloth
1 Open the top left side lid on the machine.
Part number Description
10003356 T2 Wiper Roller Gen 2 (Micro Fiber Roller)
To Next Page
Loading...
Need help?
General