Introduction
12 T2-C User Guide
Overview and application
General description
The machine consists of an unwinder/rewinder, label edge sensor, label gap and
blackmark sensor, NIP roller, slitter and 4 ink tanks.
If any changes or alterations are made to the machine, these changes or alterations must
be reflected in these instructions as necessary.
The machine's purpose and intended use
Application: The machine is only to be used to print labels.
The machine must not be used for any other purpose than the purpose mentioned above.
Warning about foreseeable misuse
The T2-C press may not be used with inks not endorsed by Trojanlabel. All inks purchased
from Trojanlabel or from official Trojanlabel distributors worldwide are endorsed by
Trojanlabel.
Technical specifications
Physical dimensions in inches and millimeters:
• Length 23.8" x Width 22.8" x Height 31.3"
• Length 606 mm x Width 580 mm x Height 795 mm
Weight:
• 132.3 lbs. (60 kg) without ink tanks and label roll
Electrical:
• Nominal supply voltage: 100-240V AC
• Nominal supply frequency: 50-60hz
• Estimated peak consumption: 240W
• Full-load current: 3.6 A
• Machine power supply:
240 W (48 VDC, 5 A), please see "T2-C_Meanwell_SP-240-SPEC.PDF" for details:
http://www.trojanextranet.com/media/59742/t2-c_meanwell_sp-240-spec.pdf
Operating positions, location, and arrangement
The machine is intended to be used in a light industrial/office environment. The operator
operates the machine in a standing or sitting position.
The machine should be placed on a properly leveled worktable or cabinet which is able to
handle the T2-C press weight and size. Use spirit level to check leveling.
Note: Improper leveling of the machine might cause print quality issues and shorten the
printhead life.
To Next Page
Loading...
Need help?
General