Maintenance
108 T2-C User Guide
Clean or replace aerosol filter
There are 2 fans that pull the ink aerosol away to a filter from the print area to prevent print
quality issues related to aerosol build up. This filter is a consumable and needs to be checked
and if necessary cleaned or replaced.
1 Open the top right lid to gain access to the filters.
2 The filter is in a drawer that can be pulled out upwards.
3 To clean the filter, use compressed air to blow it out.
4 The filter can also be washed out under the tap, but make sure it is dried before reinstalling
it.
5 To replace the filter, take it out from the drawer and replace with a clean new filter.
To Next Page
Loading...