User Interface (UI)
78 T2-C User Guide
Insert Printhead Button
Primes the newly inserted printhead with ink.
Note: Priming the printhead with ink may take several minutes.
Note: During first time installation, the printhead priming does not begin until the reservoir
tank ink levels are high enough. Pressing the Insert Printhead button might be required 2
times to prime the printhead with ink in this case.
Home Maintenance Module Button
Moves the maintenance module into the home position. Maintenance module slides out
from below the printhead. When maintenance module is in the home position it can be
inspected/cleaned and the wiper roller, cap module can be replaced.
Warning: It is not advised to keep the maintenance module in the home position for a long
period of time as the printhead is not protected and can dehydrate quickly when the
maintenance module is not protecting the printhead.
Install Maintenance Module Button
Moves the maintenance module back to the installed position (under the printhead). The
printhead is only protected properly when the maintenance module is in this position.
Circulate Ink Button
Circulates ink in the system to purge air bubbles. This function does not create waste ink
and can be run as many times as needed. One ink circulation cycle takes a few seconds
only.
Note: Ink circulation is a very useful function and can help to get rid of fine streaks
generated by air bubbles which might be blocking some printhead nozzles. It takes less
time than Light Cleaning.
To Next Page
Loading...
Need help?
General