Printing modes
T2-C User Guide 49
• AUTOSET - Simply put the gap in view and push and hold the AUTOSET button for 1
second. The AUTOSET LED will remain on when the setup is complete. If the setup is not
adequate, the AUTOSET and Output LEDs will flash 3 times. This may indicate a backing
material that is too dense to penetrate.
• UP/DN Adjustments - The Label Eye sensor has the ability to adjust the setup
incrementally. Simply momentarily tap the AUTOSET (UP) button, or LT/DK (DN) button to
adjust the sensor to a more stable and repeatable setting. This feature is used when the
AUTOSET does not provide the optimum setting initially.
Example: If the label backing material is inconsistent, or the label material has more
translucent areas coming into view, then the sensor may need to be adjusted slightly for
this rare occasion. Having the ability to fine tune the sensor for changing conditions
provides a solution that is easy to implement and simple to understand.
• Light/Dark - Push the LT/DK button to change output from Dark On to Light On. Output
turns on when the label is in view, or output turns on when the gap is in view.
1 Cut a piece from the label material which has a blackmark on it. Then put the blackmark
exactly under the middle of the LABEL • EYE™ text on the sensor, where the small dot
indicates the exact position of the sensor beam.
2 Keeping the blackmark under the sensor beam, press and hold the AUTOSET button on
the sensor until only the green AUTOSET LED is lit constantly (the red output and the green
autoset LEDs will start flashing first and then the red LED goes off and the green LED stays
lit if calibration is successful).
3 Check detection by moving a label (not blackmark) into the sensor beam. If sensor is
properly calibrated, then the red output indicator LED will go on indicating that the sensor
can differentiate between blackmark and label. When the blackmark is under the sensor,
then only the green autoset LED is lit.
To Next Page
Loading...
Need help?
General