Trojan T2-C User Manual

User Interface (UI)
T2-C User Guide 69
Important: Every time you change a setting press the blue Save button to apply the
changes.
Settings tab
• Default print queue state:
Running: (Default) Print jobs are queued progressively as they are sent and
processed in a FIFO (first in first out) system. The queue can be managed from the
Print queue menu. See “Print Queue menu” on page 82.
Paused: The print queue is paused when machine starts.
• Default batch mode:
Note: Batch mode means that the T2-C press is waiting for a certain period of time and
batches the print jobs sent during the batch mode timeout. Batched print jobs are
merged into 1 print job and printed out at once. Batched print jobs show up as 1 print
job in statistics.
Off: (default) Batch mode is switched off by default.
On: Batch mode is on.
• Default batch mode timeout (seconds):
If batch mode is on, the press is waiting for the print jobs to be sent until the timeout
interval expires. All print jobs sent during this timeout period will be merged into 1 print
job and printed out at once when the timeout expires.
• Instant print (before job sending finished): Enabled/Disabled.
Note: This function only works when printing from the optional Trojan Print Processor
(TPP) software and not from the regular T2-C driver.
When disabled the T2-C press buffers the whole print job which is being sent to the
press via the driver before actually starting to print.
When enabled the T2-C press starts printing right after buffering X seconds of print
stream (buffering time is set at next menu point).

Trojan T2-C Specifications

General

Brand	Trojan
Model	T2-C
Category	Label Maker
Language	English