Trojan T2-C - Page 96

Using the built in slitter for the T2-C press
96 T2-C User Guide
3 Loosen brass finger screw that fixes the blade holder bracket (1.) and remove the blade
holder (2.).
4 Remove the 2 screws that fix the blade onto the blade holder using a hex key size 2.5.
5 Take off the old blade and replace with a brand new blade.
6 Fix the new blade with the 2 screws (see step 4 above for screws).
7 Attach the blade holder bracket back to where it was and fix it with the screw (see step 3
above).
8 Replacement is done. Close the lid.