What causes 'Lost communication with joint 0' in Universal Robots UR5 Robotics?
If your Universal Robots robotics system is experiencing the error 'Lost communication with joint 0', it means more than one package was lost. Verify that the communication cables are properly connected and perform a complete rebooting sequence.
What causes 'Lost communication with joint 1' in Universal Robots UR5 Robotics?
If your Universal Robots robotics system is experiencing the error 'Lost communication with joint 1', it means more than one package was lost. Verify that the communication cables are properly connected and perform a complete rebooting sequence.
What causes 'Lost communication with joint 2' in Universal Robots UR5 Robotics?
If your Universal Robots robotics system is experiencing the error 'Lost communication with joint 2', it means more than one package was lost. Verify that the communication cables are properly connected and perform a complete rebooting sequence.
What causes 'Lost communication with joint 3' in Universal Robots UR5?
If your Universal Robots robotics system is experiencing the error 'Lost communication with joint 3', it means more than one package was lost. Verify that the communication cables are properly connected and perform a complete rebooting sequence.
What causes 'Lost communication with joint 4' in Universal Robots UR5?
If your Universal Robots robotics system is experiencing the error 'Lost communication with joint 4', it means more than one package was lost. Verify that the communication cables are properly connected and perform a complete rebooting sequence.
What causes 'Lost communication with joint 5' in Universal Robots robotics?
If your Universal Robots robotics system is experiencing the error 'Lost communication with joint 5', it means more than one package was lost. Verify that the communication cables are properly connected and perform a complete rebooting sequence.
What causes 'Lost communication with tool' in Universal Robots UR5?
If your Universal Robots robotics system is experiencing the error 'Lost communication with tool', it means more than one package was lost. Verify that the communication cables are properly connected and perform a complete rebooting sequence.
How to troubleshoot Lost communication with Safety Control Board A uP on Universal Robots UR5?
If your Universal Robots robotics system loses communication with Safety Control Board A uP, check the TCP/IP connection between the Motherboard and Control Board. Perform a complete rebooting sequence. If the issue persists, replace the Safety Control Board.
What causes 'Lost package from uPA to uPB' in Universal Robots robotics?
General| Payload | 5 kg |
|---|---|
| Reach | 850 mm |
| Degrees of Freedom | 6 |
| Weight | 20.6 kg |
| Repeatability | ±0.1 mm |
| Power Supply | 100-240 VAC, 50-60 Hz |
| Operating Voltage | 24 VDC |
| Protection Rating | IP54 |
| Programming Method | Polyscope graphical user interface |
| Operating Temperature | 0°C to 50°C |
| Communication Interface | Ethernet |
To Next Page
