Vacon NX series - Page 356

Table 197: Selections for parameter ID1084
Selection
number
Selection name Description
b0 Disables encoder fault
b1
Update Ramp Generator when
MotorControlMode changes
from TC (4) to SC (3)
b2
RampUp; use acceleration
ramp (for Closed Loop torque
control)
b3
RampDown; use deceleration
ramp (for Closed Loop torque
control)
b4
FollowActual; follow actual
speed value within WindowPos/
NegWidth (for closed loop tor-
que control)
b5
TC ForceRampStop; Under stop
request the speed limit forces
the motor to stop
b6 Reserved
b7
Disables switching frequency
decrease
b8
Disable the parameter "Run
state parameter lock"
b9 Reserved
b10 Invert delayed digital output 1
b11 Invert delayed digital output 2
1085 BRAKE ON/OFF CURRENT LIMIT 6 (2.3.4.16)
The mechanical brake closes immediately if the motor current is below this value.
This parameter is available for NXP drives only.
VACON · 356 PARAMETER DESCRIPTIONS
8
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205