Valleylab Force FX-C - Page 137

Responding to System Alarms
Number
Description
Recommended Action
164-166
Dosage error while activating a bipolar
Repeat the failing calibration step. If the number reappears,
mode or a cut mode.
record the number and call the Valleylab Service Center.
170
Watchdog malfunction. Correct value not
Refer to Correctlf7g IC UB Malfunctions in th is section.
sent from feedback microcontroller.
171
Watchdog malfunction. Correct value not Refer to Correcting IC U3 Malfunctions in this section.
sent from main microcontroller.
172
Watchdog malfunction. Main
microcontroller unable to access
watchdog semaphore.
173
Watchdog malfunction. Feedback Refer to Correcting IC UB Malfunctions in this section.
microcontroller unable to access
watchdog semaphore.
174 Software malfunction. which .. errors value
Turn off, then turn on the generator. If the alarm number
a
c:
outside state range reappears, record the number and call the Valleylab Service
0-
GenteL
m
.(J)
:::r
0
180 Internal diagnostics. Main microcontroller Refer to Correcting IC U3 Malfunctions in this section.
0
:::t.
WSI RAM check failed.
::::l
co
181
Internal diagnostics. Feedback
Refer to Correcting IC UB Malfunctions in this section.
microcontroller WSI RAM check failed.
182
Internal diagnostics. Main microcontroller Refer to Correctlf7g IC U3 Malfunctions in this section.
dual-port RAM check failed.
183
Internal diagnostics. Main microcontrolier
Page 0 (zero) ROM CRC test failed.
184 Internal diagnostics. Main microcontroller
Page FROM CRC test failed.
185 Internal diagnostics. Feedback Refer to Correcting IC U6 Malfunctions in this section.
microcontroller ROM GRC test failed.
189
Software malfunction. display_state value
Turn off, then turn on the generator. If the alarm number
outside state range.
reappears, record the number and call the Valleylab Service
Genter.
Force FXTM-C Service Manual
6-15