7.4 Servicing 40
7.5 Warranty 40
7.6 Maintenance table 41
7.6.1 Once per day 41
7.6.2 Once per week 41
7.6.3 Every 2 years 41
7.6.4 When necessary 41
7.7 Spare parts and wear parts 42
7.7.1 Definition of wear parts 42
7.7.2 Spare part list 42
7.8 Cleaning the machine 44
7.8.1 Performing the daily cleaning 44
7.8.2 Performing the weekly cleaning 45
7.9 Cleaning or replacing the collet chuck of the spindle 47
7.9.1 Removing the collet chuck 47
7.9.2 Cleaning the collet chuck 48
7.9.3 Greasing the collet chuck 48
7.9.4 Inserting the collet chuck 48
7.10 Exchanging clamping devices and blank holders 50
7.10.1 Exchanging clamping devices 50
7.10.2 Exchanging the blank holder 51
7.11 Exchanging tool magazine inserts and associated
holders 54
7.12 Exchanging the bellow 59
7.13 Exchanging the spindle unit 66
7.14 Exchanging the system module 73
7.15 Exchanging the system module locking bolt 76
7.16 Exchanging the measuring key protective cap 78
7.17 Exchanging the measuring key 79
7.18 Exchanging the fuser latches and clamping blocks on
the upper service cover 81
7.19 Exchanging the fuser latches and clamping blocks on
the lower service cover 83
7.20 Exchanging the gasket of the working chamber door 85
7.21 Exchanging the A-B axis module cover caps 87
7.22 Exchanging the working chamber door 88
7.23 Exchanging the A-B axis module 90
7.24 Exchanging the main fuse 94
7.25 Calibrating the axes 95
7.26 Updating the software and firmware 96
7.26.1 Updating DENTALCAM & DENTALCNC 96
7.26.2 Updating the firmware of the machine 96
8 Troubleshooting 97
8.1 Links to troubleshooting guides 97
8.2 Machine-specific notes 97
8.2.1 Loud machining noise 97
8.2.2 How to proceed in the event of a machine mal-
function 97
8.2.3 How to proceed in the event of a tool breakage 97
8.2.4 How to proceed in the event of a power failure 97
8.3 Emergency opening of the working chamber door 99
8.4 Removing broken tools from the collet chuck 100
9 Disposal 101
9.1 Disposing machining residues 101
9.1.1 General 101
9.1.2 Solid machining residues 101
9.2 Disposing of the machine 101
9.3 Dismantling, transport and packaging 101
Index 102
Original Operating Instructions:E5
Version: 4/27/2023
Contents
EN 4
To Next Page
Loading...
