5. Clamp the spare gasket to the edge surrounding
the opening to the working chamber:
a. Clamp one of the open ends of the gasket to
the top edge of the opening.
b. Clamp the remaining part of the gasket clock-
wise.
Ensure that the entire gasket is firmly clamped
to the edge.
FIG. 240
FIG. 241
FIG. 242
6. Check whether the working chamber door opens
and closes correctly and whether the working
chamber door lies flat.
7. If this is not the case, adjust the placement of the
gasket.
Original Operating Instructions:E5
Version: 4/27/2023
Maintenance
EN 86
To Next Page
Loading...
