Hitching the implement
43
Check the cable routing
Check the cabl e routing. The cable must shown no si gns of abrasi on
or sagging. Torn or f rayed cables can cause unforeseen movements
on the implement.
Check the following connections between the tractor and the imple-
ment:
•
hydraul ic connections,
•
electronic connections and
•
compressed air connections (where applicable)
Connecting the
hydraulic
quick-release
coupling
Connect the hydraulic li nes as foll ow s:
> Check that the quick-release couplings are clean.
> Connect the quick-release couplings to the tractor.
> Ensure that the tractor's hydraulic system is not pressurised.
> Connect the blue quick-release coupling for the rotor
uncoupli ng [ +] to a singl e acti ng control device.
> Connect the black quick-release coupling for the pick-up equip-
ment and the knives to a single acting control device.
> Connect the yellow quick-release coupling from the rear flap clos-
ure to the double-acti ng control device.
> Connect the red quick-release coupling from the rear flap opening
to the double-acting control device.
> Connect the quick-release coupling for the hydraulic brake [+] to
the corresponding retai ner.
Retainers
Quick-release cou-
Ball valve
Blue
Black
Yellow
Red
To Next Page
Loading...
