Maintenance
95
Pick-up equipment
and rotor
N
OTE
Working with the grease gun
Lubri cate t he beari ngs wi th one or tw o presses of the grease gun. If
you feel resi stance at the second press, do not press a second ti me.
Too much grease wi ll force the beari ngs apart. Thi s wi l l al l ow forei gn
bodies to enter the bearing, resulting in premature wear.
Pic k- up eq ui pm e nt,
overload coupling,
OptiCut and rotor
Raise the pick-up equipment to the highest position.
> Lubricate the lubrication points.
Rotor cu tterba r
> Always lubricate the lubrication points for the cutterbar rotor after
500 bales.
Pick-up equipment
chain wear
The pick-up equipment chain must be replaced when the chain tensio-
ner is just in front of the end stop.
> Measure the pick-up equipment drive chain and replace if neces-
sary.
Lubrication
point
Lubrication
point
To Next Page
Loading...
