Preparations in the field
71
Baler check list
Before bale producti on, the fol lowing must be checked:
•
Net inserted?
•
Tw i ne i nserted?
•
AutoPl us-Pi lotbox on?
•
Bale densit y set?
•
Tractor PTO shaft switched on at a lower speed and brought to
540 rpm?
•
Pick-up equipment adjusted to the correct height?
•
Rear fl ap closed?
•
Rear fl ap closed and pressure confi gured?
•
Scraper set?
•
Baffl e pl ate set?
Setting the baffle
plate
The baffle plate ensures that the crop feeds correctly . Especially short
cut crops in windy weather.
Baffle plate
The baffle pl ate can be attached in different positions.
> Switch off the tractor and secure it.
> Support the baffl e plate w i t h one hand.
> Fit the chain on both sides of the implement in the required positi-
on.
> Release the baffle plate slowly.
N
OTE
The underside of the baffle plate should come into contact with the
swat h evenl y.
Fi t both chains at the same height. For i mproved pickup of the crop,
an optional roller for the baffle plate is provided.
→
»Roller for baffle plate«, page 118.
Chain
To Next Page
Loading...
