Driving on the road
67
Emptying the bale
chamber.
Before road transport, the crop must be remov e d from the bale cham-
ber. Proceed as follow s:
If bale production is not possible, remove the remaining crop from the
bale chamber.
> Carry out the »Cleaning the bale cham ber« operating instructions,
page 81.
If bale production is possible, release the bale.
> Carry out the »“MANUAL/AUTO” program changeo ver« operating
instructions on page 67.
“MANUAL/AUTO”
program ch ang eo ver
The fol low i ng operati ng modes can be selected wi th the AutoPl us- Pi -
l otbox for net tyi ng and twi ne ty i ng:
•
AUTO: Automatic start of bal e tying
or
•
MAN UAL: Bal e tyi ng start s wi t h the “GO” button
> The display shows automatic tying is active.
> Press the “MANUAL/AUTO” button:
> The display shows manual tying.
> Press the “GO” button. Net tying is triggered.
> The display shows “tying start” during bale wrapping.
> The display shows “rear flap open” after successful bale wrapping
and the cutting of the tyi ng material s.
> Carry out the »Depositing the bale« op erating instructions on page
79.
N
OTE
These operating instructions are also applicable for twine tying.
To Next Page
Loading...
