70
Preparations in the field
Preparati ons in the field
Safety
Observe safety instructions
Observe the safety instructions for the performance of all work. Any
di sregard for safety i nstr ucti ons can lead to serious or fatal i njuri es to
persons.
Secure the tractor
Before you dismount: Switch off the tractor, take out the ignition key
and secure the tractor against rolling away. An unsecured tractor may
run you over or trap you. There is otherwise the risk of serious or fatal
injury.
Securing the implement
Secure the implement against inadvertent starting and rolling away.
Use wheel chocks. The implement must be standing on firm and lev el
ground and, if necessary, must be supported during work. Unsecured
or non-supported impl ements can cause accidents. There i s otherwi -
se the risk of serious or fatal injury.
Always switch off the AutoPlus-Pilotbox when working on the
implem ent
Al w ays sw i t ch off the pilot box w hen w orki ng on the i mpl ement. If t he
Pilotbox is switched on or st arts inadv ertently, unfo rese en mov ements
may be triggered on the implement. This can cause accidents with fa-
tal consequences.
Do not upset the cardan shaft
The cardan shaft between the tractor and implement must not be jol-
ted in any operating or transport position. Upset cardan shafts can
cause damage to the implement and tractor.
I ncreases in pressure are prohibited
It i s prohi bited to i ncrease the maximum worki ng pressure setting for
the bale density on the hydraulic block. Attem pting to do so will render
the warranty invalid and exempt the manufacturer from all liability. Da-
mage may be caused to the implement.
General
The implement must be adjusted in the operating position. This is de-
scribed in the following chapter:
•
Baler check list.
•
Adjust the baffl e pl ate.
•
Adjust the bal e density .
To Next Page
Loading...