46
Preparing for use
General
conditions
The following applies for all preliminary provisions:
•
Secure the tractor and the implement.
•
Check the tyre pressure.
Before commissioning the implement, the followi ng work steps must
be carri ed out, as descri bed in thi s chapter:
•
Open the rear flap.
•
Close the rear flap.
•
Adjust the roller feelers.
•
Adjust the pi ck-up equipment.
•
Adjust the OptiCut cutterbar.
•
Insert the twine.
•
Insert the net.
•
Adjust the bal e density .
•
Adjust the scraper.
Open i ng the rear flap
> Open the rear flap via the control device.
Switch off the AutoPlus-Pilotbox.
> Press the “ON/OFF” button.
> Switch off the tractor, take out the ignition key and secure it.
> Close the rear flap hydraulic manifold ball valve. The hydraulic ma-
nifold is located between the drawbar . When closed, the open rear
flap is secured.
Clo si ng the rear fla p
> Open the rear flap hydraulic manifold ball valve . When open, the
rear fl ap i s no longer secured and can be closed.
> Switch the tractor on.
Switch on the AutoPlus-Pilotbox.
> Press the “ON/OFF” button.
> Close the rear flap via the control device.
> Leave the control device lever in rear flap closed position for appro-
xi matel y 3 seconds, to buil d up the pressure for the defaul t bal e
density.
Rear flap ball
valve
Rear flap ball
valve
To Next Page
Loading...
