82
Cleaning and care
Cl eaning an d care
Safety
The following applies to all cleaning and care work:
Observe safety instructions
Observe the safety instructions for the performance of all work. Any
di sregard for safety i nstr ucti ons can lead to serious or fatal i njuri es to
persons.
Securing the implement
•
Before starti ng the cleani ng w ork, al w ay s swi tch off the cardan
shaft and lock it out against accidental operation.
•
Secure the implement against rolling away by using wheel wedges.
•
The implement must be standing on firm and level ground and, if
necessary, must be supported during work.
Unsecured or non-supported implements can cause accidents.
Do not clean bearings or hydraulic parts wit h high pressure cle-
aners
Do not cl ean beari ngs or hy draul i c parts with hi gh pressure cleaners.
The high-pressure cleaner removes the grease film from the bare me-
tal surfaces. Metal surfaces treated with grease can corrode. After
each cleaning process, lubricate the bearing points and grease the ba-
re parts.
Clean the bearings and hydraulic parts carefull y
Cauti on when cleani ng wi th a high-pr essure cl eaner. Beari ngs, seals
and pipe unions are not waterproof. Avoi d damaging the implement;
the bearings, seals and pipe unions must not come into direct contact
with the high pressure water jets.
Do not clean the electrical parts with high pressure
Do not clean the AutoPlus-Pilotbox, control box and electrical plug
connections with a high pressure cleaner . Moisture or water in electro-
ni c devices can lead t o l eakage current, w hich results i n malf uncti on.
Damage may be caused to the implement.
To Next Page
Loading...
