78
Operation
Manual
tying
For manual tying, a signal i s emitted by the AutoPlus-Pilotbox when
the preset bal e densit y is reached. A fill ing level of 90% i s display ed
on the AutoPlus-Pilotbox at the same time. As soon as 100% bale
densit y i s reached, proceed as fol l ow s:
> The AutoPlus-Pilotbox signal sounds.
> “Bal e density 90%” i s displ ay ed.
> “Bale density 100%” is displayed.
> Stop the tractor immediately.
> Press the “GO” button. Net or twine tying is triggered and the signal
stops.
> The display shows “tying start” during bale wrapping.
> The display shows “Open rear flap” after success ful bale wrapping
and cutting of the tying material.
> The AutoPlus-Pilotbox signal sounds.
> Carry out the »Depositing the bale« operating instructions, page
79.
N
OTE
These operating instructions are also applicable for twine tying.
To Next Page
Loading...
