Rev AB CLARiTY Error messages 8-13
Videojet 8520 Operator Manual
E3013 ‘Printhead Absent’ - Communications between
CLARiTY and the printer have been lost, check the
cabling.
Fault
E3016 ‘Printhead Volts Error’ Fault
E3024 ‘24 Volt Error’ - The 24 volts supply is not in the working
range. Power the printer OFF and ON to try and clear
the fault. If the problem persists, call your maintenance
engineer or local service representative.
Fault
E3025 ‘Printer Ambient Temperature’ - The internal ambient
temperature of the printer is outside its recommended
operating range. Touch the Clear button below to clear
this warning.
Warning
E3026 ‘External Error’ - The operation of the printer has been
suspended by the control system. If the Clear button is
available below, you may touch it to clear this error and
resume printing.
Fault
E5342 ‘Printhead X - Ink Type Not Allowed’ - The ink type of the
cartridge in printhead X is not on the allowed ink list for
this controller. The cartridge needs to be replaced with
an allowed ink type, or an administrator needs to add
the ink type to the allowed ink list. To clear this fault
press the Replace Cartridge button and follow the
instructions.
Fault
E5343 ‘Group X - Ink Type Not Allowed’ - The ink type of the
cartridge in group X printhead X is not on the allowed ink
list for this controller. The cartridge needs to be replaced
with an allowed ink type, or an administrator needs to
add the ink type to the allowed ink list. To clear this fault
press the Replace Cartridge button and follow the
instructions.
Fault
E5344 The cartridge in printhead X is not authenticated. The
standard firing parameters will be used and can be
adjusted in the Tools > Setup > Consumables. The ink
level will not be tracked and other printer functions may
not be available, please refer to the operator’s manual
for more details.
Warning
E5345 'Group 1- Non-Authenticated Cartridge' - The cartridge
in group X printhead X is not authenticated. The
standard firing parameters will be used and can be
adjusted in the Tools > Setup > Consumables. The ink
level will not be tracked and other printer functions may
not be available, please refer to the operator’s manual
for more details.
Warning
Error
No
Report on CLARiTY Operator Interface Status
Table 8-6: CLARiTY Error Messages (Continued)
To Next Page
Loading...
