VIDEOJET 8520 - Page 149

8-12 CLARiTY Error messages Rev AB
Videojet 8520 Operator Manual
E1204 ‘Invalid Job File (Application Identifier Incorrect)’ -
Application Identifier contains non-numeric data -
correct in CLARiSOFT
Warning
E1205 ‘Invalid Job File (Application Identifier Length Incorrect)’
- Application Identifier 23 requires a length digit - correct
in CLARiSOFT
Warning
E1206 ‘Invalid Job File (EAN Field Incorrect Length)' - EAN
barcode does not have expected number of digits
specified by Application Identifier - correct in
CLARiSOFT
Warning
E1207 ‘Invalid Job File (EAN barcode out of specification)’ -
Separator character being used to terminate barcode
data - correct in CLARiSOFT
Warning
E1208 ‘Invalid Job File (EAN field value out of range)' - Data
out of range, example '13' for a month code or '25' for an
hour code - correct in CLARiSOFT
Warning
E1209 ‘Invalid Job File (EAN requires decimal point specifier)’ -
EAN requires digit to specify the position of the decimal
point - correct in CLARiSOFT
Warning
E1210 ‘Invalid Job File (EAN field invalid or missing check
digit)' - Application identifier requires the missing check
digit - correct in CLARiSOFT
Warning
E1211 ‘Invalid Job File (EAN over 165 mm long)' - Barcode too
large - resize to maximum length of 165 mm - correct in
CLARiSOFT
Warning
E1212 ‘Invalid Job File (Barcode Length Incorrect)' - Barcode
field does not have expected number of characters -
correct in CLARiSOFT
Warning
E1213 ‘Invalid Job File (barcode out of limits)' - Barcode
overruns image area. Resize image area to
accommodate the barcode - correct in CLARiSOFT
Warning
E1300 ‘Slave Printer Absent’ - Communications between the
Master printer and the Slave have been lost - check
cabling.
Fault
E1301 ‘Master Printer Absent’ - Master printer configured
incorrectly (Slave) - check configuration and cabling
Fault
E1302 ‘Slave Job Select Failed’ - Communications between the
Master and Slave printer is lost - check cabling.
Fault
Error
No
Report on CLARiTY Operator Interface Status
Table 8-6: CLARiTY Error Messages (Continued)