WEG SSW-06 - Page 109

CHAPTER 6 - DETAILED PARAMETER DESCRIPTION
109
Range
[Factory Setting]
Parameter Unit Description / Notes
 Parameters with note (2) indicated are not changed when Factory
Settings are loaded through P204 = 5.
 To load User 1 Parameters (P204=7) and/or User 2 (P204=8) in
the operation area of Soft-Starter SSW-06, it is necessary for User
Memory 1 and/or User Memory 2 to have been saved previously
(P204=10 and/or P204=11).
P204
(1)
0 to 16
Load/Save [0]
Parameters -
Figure 6.11 - Parameter transfer
The table below shows the relation between the adopted starting
control type and the automatically selected stop control type.
Table 6.21 - Stop/Start operation
User
Memory 1
Factory Setting
(WEG Stan-
dard)
P204=5
Current
Parameter of
Soft-Starter
SSW-06
User
Memory 2
P204=11
P204=10
P204=7
P204=8
STOP
Voltage Ramp CurrentLimit Current Ramp Pump Control Torque Control
START
Voltage Ramp X
CurrentLimit X
Current Ramp X
Pump Control X
Torque Control X