WEG SSW-06 - Page 6

Summary
3.3 Recommended Set-Ups ...................................................................59
3.3.1 Recommended Set-ups using Keypad Command
with Isolating Contactor. .............................................................61
3.3.2 Recommended Set-ups using Keypad Command
with Circuit-breaker ....................................................................61
3.3.3 Recommended Set-ups with Command via Two-wire
Digital Inputs ...............................................................................62
3.3.4 Recommended Set-ups with Command via Three-wire
Digital Inputs ...............................................................................62
3.3.5 Recommended Set-ups with Command via Three-wire
Digital Input and Inside Delta Motor Connection. ....................... 63
3.3.6 Recommended Set-ups with Command via Three-wire
Digital Input or Serial Communication. .......................................63
3.3.7 Recommended Set-ups with Command via Three-wire
Digital Input or Fieldbus Communication. ...................................64
3.3.8 Recommended Setup with Command via Digital Inputs
and direction of rotation. ............................................................ 64
3.3.9 Recommended Setup with Command via Digital Inputs
and Reverse Braking .................................................................. 65
3.3.10 Recommended Setup with Command via Digital Inputs
and Optimal Braking ................................................................. 65
3.3.11 Recommended Setup with Command via Digital Inputs
and DC-Braking ......................................................................... 66
3.3.12 Recommended Setup with Command via Digital Inputs
and External By-pass Contactor ...............................................66
3.3.13 Symbols ....................................................................................67
3.4 European Directives for Electromagnetic Compatibility
Requirements for Installation .........................................................68
3.4.1 Installation ..................................................................................68
CHAPTER 4
Keypad Operation
4.1 Description of the Keypad (HMI-SSW-06) ....................................... 69
4.2 Use of the Keypad ...........................................................................71
4.2.1 Keypad use for Soft-Starter SSW-06 Operation ......................... 71
4.2.2 Keypad Display - Signalling Indications .....................................72
4.2.3 Parameter viewing and programming ........................................73
CHAPTER 5
Start-up
5.1 Power-up Preparation.......................................................................76
5.2 Initial Power-up (required parameter settings) .................................77
5.3 Start-up ............................................................................................. 84
5.3.1 Start-up: Operation via Keypad Type of Control: Voltage Ramp 84