Weidmüller THM MultiMark Plus - Loading Fanfold Media

50 2599440000/00/04.2019
Loading Material
4.2 Loading Fanfold Media
5
1
2
3
4
Figure 12 Feed path of fanfold media
f Turn ring (2) counterclockwise, so that the arrow points to the symbol , and thus release the margin
stop (1).
f Position guides (5) so that they are several millimeters wider than the material.
f Position media stack (4) behind the printer. Ensure that labels on the strip are visible from above.
f Guide the media strip over the roll retainer (3) to the print unit.
f Move the margin stop (1) against the media strip until both margin stops touch the media strip without
clamping or bending it.
f Turn ring (2) clockwise, so that the arrow points to the symbol ,andthusxthemarginstop(1)onthe
roll retainer (3).
f Insertmediastripintoprinthead(→„4.1.2 Inserting the Media into the Printhead“ on page 49).
f Setthelabelsensor(→„4.1.3 Setting the Label Sensor“ on page 49).
f Settheheadlockingsystem(→„4.3 Setting the Head Locking System“ on page 51).
f Turn lever (5) clockwise to lock the printhead.