8 Lock
8.1 Lock on the cylinder
Prerequisites:
n The administrator has instructed key holders on how to
use the locking system.
n The key is authorised to lock.
1. Insert the key into the cylinder as far as it will go.
2. Ensure that the key's side struts fully fit into the cyl-
inder slot.
3. Turn the key up to 720° to the right.
ð
The door is open.
4.
NOTICE!
Damage caused by pulling out keys
incorrectly.
Pull the key out straight.
5.
NOTICE!
Damage caused by trying to pull the
door open with the key.
Open door with the door handle or knob.
Prerequisites:
n The administrator has instructed key holders on how to
use the locking system.
n The key is authorised to lock.
1. Insert the key into the cylinder as far as it will go.
2. Ensure that the key's side struts fully fit into the cyl-
inder slot.
3. Turn key to the left 360° (single-turn cylinder) or 720°
(two-turn cylinder).
ð
The door is locked.
4.
NOTICE!
Damage caused by pulling out keys
incorrectly.
Pull the key out straight.
Unlock
Locking procedure
Lock
23.03.2020 blueCompact electronic locking system 137
To Next Page
Loading...
