4. Ensure that the PUK card scratch-o panel is undam-
aged.
5. Close packaging and leave contents in the packaging
until installation or use.
3.3 Storing
Locking system components which do not contain batteries
can be stored in a drawer or cupboard at room tempera-
ture.
Batteries are contained in battery replacement sets and
fitted into the following locking system components:
n Active key
–
Ä
Chapter 1.2.1 “Active keys” on page 16
–
Ä
Chapter 10.3.1 “Replace the battery in an active key”
on page 156
n Cylinder
–
Ä
1.5 “Cylinder” on page 24
–
Ä
10.3 “Replace batteries” on page 154
1.
NOTICE!
Damage to batteries and self-discharge
due to incorrect packaging.
You must ensure you do the following when
(re-)packing batteries:
n Protection against short circuits is in place
n Batteries are separated from one another with non-
conductive material
n Battery terminals are not subjected to the weight of
the batteries above them
Do not unpack the batteries until just
before you insert them into the key or
cylinder.
Pack batteries
Fig. 22: Batteries
Transport and store
23.03.2020blueCompact electronic locking system42
To Next Page
Loading...
