4 Select and install cylinder
NOTICE!
Physical damage caused by using force to fit
the cylinder.
You can damage cylinders or parts of the
door if you use force to fit cylinder.
– Determine the type of cylinder required.
–
Ä
Chapter 4.2 “Determine cylinder
type” on page 49
–
Ä
Chapter 4.3 “Determine cylinder
length” on page 50
– Carefully push cylinder into the door lock.
– Contact specialist company if you have
problems with installation.
NOTICE!
Damage caused by incorrect cleaning.
You must not clean or apply lubrication to
the cylinder. Applying oil to the cylinder can
damage the built-in electronics beyond
repair.
– Do not apply oil or grease to cylinders.
– Do not treat cylinders with graphite.
– Do not allow the cylinder to come into
contact with paint or thinner.
NOTICE!
Physical damage due to face plate screws
screwed into place incorrectly.
Face plate screws which do not grip into the
cylinder thread may cause damage just as
easily as face plate screws tightened too
firmly.
– Ensure that the face plate screw grips into
the designated thread in the cylinder.
– Use a screwdriver to tighten face plate
screw by hand.
Material damage
Select and install cylinder
23.03.2020 blueCompact electronic locking system 45
To Next Page
Loading...
