Winkhaus blueCompact - Use Internal Power Function

1.2.1.2 Use internal power function
If the cylinder battery is flat, the lock can be
operated using the battery in an active key.
WARNING!
Hazard to persons due to malfunction in
emergency opening with an active key.
Active keys with a low battery may not be
able to open or close cylinders with a flat
battery.
– Check the battery charge status in all com-
ponents on a regular basis.
– Ä Chapter 7.3.3 “Identify key”
on page 85
– Ä Chapter 7.7 “Open system informa-
tion” on page 124
–
Ä Chapter 7.4.4 “Check the cylinder
battery charge status” on page 90
– Immediately replace batteries with a low
charge level with new, approved batteries.
– Ä Chapter 10.3 “Replace batteries”
on page 154–
–
Ä “Battery life” on page 185
Precondition:
n The battery in the cylinder is flat.
1. Insert active key into the cylinder.
2. Activate active key by pressing on the button (2) for 2
seconds.
ð
The LED display (3) on the active key lights up
yellow and the lock can be operated using the
power in the battery (1) in the active key.
Operate the cylinder
Fig. 7: Use internal power function
Product overview
23.03.2020blueCompact electronic locking system20