R01.i RT System 2 v2.3 Deployment Guide 121
© 2010-2014 Wireless Seismic, Inc. All rights reserved.
5. Point-to-Multipoint Backhaul
Final Communication Test
2 Make a note of the line segment radio IP addresses, or keep the Discovery window open
for easy reference:
______.______.______.______
______.______.______.______
______.______.______.______
______.______.______.______
3 The speed test should be run from the recording truck radio to the line segment radios.
Log in to the recording truck radio as described in step 2 on page 107 through step 8 on
page 109.
4 Verify that browser pop-ups are allowed:
Ź Firefox – Tools ĺ Options ĺ Content ĺ clear the Block pop-up
windows check box
ĺclick OK
Ź Internet Explorer – Tools ĺ Internet Options ĺ Privacy ĺ clear the
Turn on Pop-up Blocker check box
ĺ click OK
Ź Chrome – Settings button ĺ Settings ĺ Show Advanced Settings ĺ
Privacy area
ĺ Content Settings ĺ Pop-ups area ĺ Allow all sites to
show pop-ups
ĺ click Done
5 Click Tools
ĺ Speed Test.
6 In the Speed Test window, perform the following steps:
a Click the IP address for a line segment radio in the Select Destination IP list:
Figure 5–19 Tools, Speed Test
To Next Page
Loading...