82 RT System 2 v2.3 Deployment Guide R01.i
© 2010-2014 Wireless Seismic, Inc. All rights reserved.
4. Point-to-Point Backhaul
Final Communication Test
To run the speed test:
1 Verify that all radios are listed in the Ubiquiti Discovery Tool as described in step 4 on
page 73 through step 6 on page 74.
2 Make a note of the following IP addresses:
Ɣ The last radio in the line segment, that is, the radio farthest away from the recording
truck:
______.______.______.______
Ɣ The radio at the recording truck:
______.______.______.______
3 The speed test should be run from the recording truck radio to the radio farthest from
the recording truck. Log in to the recording truck radio as described in step 4 on page 73
through step 8 on page 74.
4 Verify that browser pop-ups are allowed:
Ź Firefox – Tools ĺ Options ĺ Content ĺ clear the Block pop-up
windows check box
ĺ click OK
Ź Internet Explorer – Tools ĺ Internet Options ĺ Privacy ĺ clear the
Turn on Pop-up Blocker check box
ĺ click OK
Ź Chrome – Settings button ĺ Settings ĺ Show Advanced Settings ĺ
Privacy area
ĺ Content Settings ĺ Pop-ups area ĺ Allow all sites to
show pop-ups
ĺ click Done
5 Click Tools
ĺ Speed Test.
6 In the Speed Test window, perform the following steps:
a Click the IP address for the radio farthest from the recording truck in the Select
Destination IP list:
Figure 4–18 Ubiquiti airOS Tools
To Next Page
Loading...