R01.i RT System 2 v2.3 Deployment Guide 123
© 2010-2014 Wireless Seismic, Inc. All rights reserved.
5. Point-to-Multipoint Backhaul
Final Communication Test
– Poor line-of-sight
– Bad antenna connection
– Faulty hardware (cable and/or antenna)
Ź WSI-MAX (AirMax) Capacity >40%. If the value is < 40%, note the following:
– The maximum capacity for the titanium bullet is 50%
– Capacity is a reflection of quality. If the quality improves, the capacity
should also improve.
– Poor capacity is typically the result of a misaligned antenna.
Ź Click AP Information in the Monitor area. Verify that the Access Point Signal
Strength is between -80 dBm and -65 dBm.
c Verify that line station radios are pointing in the correct direction.
d Raise the mast towers to provide the least obstructed view as is reasonable.
e Check the condition of the antenna panels.
f Check for frayed cables or water intrusion.
To Next Page
Loading...