Xerox 4595 - Page 43

Xerox 4595 Copier/Printer User Guide
2-17
2. Copy
 Copy All (Full Screen)
To prevent image loss, the document is reduced to just below
100% when it is copied. If this option is selected, a check mark
appears in the Copy All check box.
KEY POINT: If you select Copy All, you need to set border erase
dimensions to 0 inches (0 mm), depending on the size of the
original document. Note that even if the border erase is set to 0
inches (0 mm), the edge of the copied document sometimes
appears dirty or image loss sometimes occurs depending of the
size of the original.
When Variable% is Selected
You can enter any ratio for copying. Set the ratio within the range
from 25 to 400% in 1% increments.
1. Select Variable%.
2. Specify the ratio with the numeric keypad or the up and
down buttons.
If you enter an incorrect value, select C.
When Independent X-Y% is Selected
You can specify different height and width ratios to scale the
height and width independently.