Xerox 4595 - Page 66

Xerox 4595 Copier/Printer User Guide
2-40
2. Copy
 Center
Shadows in the center of documents such as booklets or
documents with facing pages are erased. You can set the center
erase width within the range from 0 to 1.9 inches (0 to 50 mm) in
0.1 inch or 1 mm increments.
 Original Orientation
Refer to “Original Orientation” on page 2-47.
 Side 2
• Same as Side 1
Select this item when you want the same settings for both
Side 1 and Side 2.
• Opposite to Side 1
Select this item when you want the symmetry settings for
both Side 1 and Side 2.
When 4 Equal Edges is Selected:
You can specify the same value for the top, bottom, left and right
edges.
1. From the All Services screen, select Copy, then the Scan
Options tab. From the Scan Options screen that appears,
select Edge Erase and then 4 Equal Edges.
2. Use the up and down buttons to enter the value for the
Edge Erase.
3. Select Save to save the changes.
 4 Edges
Erases shadows at the top, bottom, left and right of the copies.
You can set the border erase width within the range from 0 to 1.9
inches (0 to 50 mm) in 0.1 inch or 1 mm increments.