Xerox 4595 Copier/Printer User Guide
2-39
2. Copy
When 4 Independent Edges is Selected:
You can specify different values for the top, bottom, left and right
edges.
1. From the All Services screen, select Copy, then the Scan
Options tab. From the Scan Options screen that appears,
select Edge Erase and then 4 Independent Edges.
2. Use the up and down buttons to enter the value for the
Edge Erase.
3. Select Save to save the changes.
îš„ Top Edge
Erases shadows at the top of the copies. The edges are erased
based on the orientation of the document set.
You can set the border erase width within the range from 0 to 50
mm in 1 mm increments.
îš„ Bottom Edge
Erases shadows at the bottom of the copies. The edges are
erased based on the orientation of the document set.
You can set the border erase width within the range from 0 to 1.9
inches (0 to 50 mm) in 0.1 inch or 1 mm increments.
îš„ Left Edge
Erases shadows at the left of the copies. The edges are erased
based on the orientation of the document set.
You can set the border erase width within the range from 0 to 1.9
inches (0 to 50 mm) in 0.1 inch or 1 mm increments.
îš„ Right Edge
Erases shadows at the right of the copies. The edges are erased
based on the orientation of the document set.
You can set the border erase width within the range from 0 to 1.9
inches (0 to 50 mm) in 0.1 inch or 1 mm increments.
To Next Page
Loading...
Need help?
General