July 2019
4-39
Xerox® B205/B215 Multifunction Printer Service Manual
REP 4.12
Repairs / Adjustments
Initial Release
REP 4.12 Exit Sensor
Parts List on PL 4.5
Removal
1. Remove the following covers:
a. Remove the Left and Right Side Covers,RE
P 2.2.
b. Remove the Rear Cover, REP 2.3.
2. Remove the Fuser Module.
3. Press the latch on the underside of the frame t
o release the Exit Sensor Mounting Plate
fr
om the frame, Figure 1
.
Figure 1 Exit Sensor Plate Latch Release (Bottom View)
4. Remove the Exit Sensor, F
igure 2:
a. Release the wires from the cable clamps.
b. Unlatch the Exit Sensor, remove the Exit Sensor, then disconnect the connector.
Figure 2 Exit Sensor Removal (Rear View)
Replacement
The replacement is the reverse of the removal procedure.
To Next Page
Loading...
