July 2019
4-22
Xerox® B205/B215 Multifunction Printer Service Manual
REP 4.4, REP 4.5
Initial Release
Repairs / Adjustments
5. Remove the Transfer Roll, Figure 2:
a. Lift the right end of the Transfer Roll and slide the left end out of the bushing.
Figure 2 Removing the Transfer Roll
Replacement
The replacement is the reverse of the removal procedure.
REP 4.5 LSU and Cables
Parts List on PL 4.1
Removal
1. Switch off the printer, then disconnect the power cord.
2. Remove the Middle Cover, R
EP 2.5.
3. To replace the LSU Cables, Figure 1:
• Disconnect two connectors at the LSU.
• Disconnect the connector at the Main PWB.
Figure 1 LSU Cable Connectors and Wire Harness (Top View)
NOTE: The Flat Cable may be adhered to the LSU. Detach it from the LSU and reinstall it
on t
he new LUS in the same location.
LSU Connectors
Wire Harness
To Next Page
Loading...
