July 2019
ix
Xerox® B210 Service Manual
Regulatory Specifications
Introduction
Initial Release
Regulatory Specifications
Xerox has tested this product to electromagnetic emission and immunity standards. These
standards are designed to mitigate interference caused or received by this product in a typical
office environment.
United States (FCC Regulations)
The Xerox
®
B210 has been tested and found to comply with the limits for a Class A digital
device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a commercial installation. This equipment generates,
uses, and can radiate radio frequency energy. If it is not installed and used in accordance with
these instructions, it may cause harmful interference to radio communications. Operation of
Class A equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his/her own expense. There is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference t
o radio or television reception, which can be
determined by turning the equipment Off and On, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiver.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiv
er
is c
onnected.
• Consult the dealer or an experienced radio/television technician for help.
Any changes or modifications not e
xpressly approved by Xerox could void the user's authority
t
o operate the equipment. To ensure compliance with Part 15 of the FCC rules, us
e shielded
int
erface cables.
Canada (Regulations)
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme
à la norme NMB-003 du Canada.
European Union
This product, if used properly in accordance with the user's instructions, is neither dangerous
for the consumer nor for the environment.
To ensure compliance with European Union regulat
ions, use shielded interface cables.
A signed copy of the Declaration of Conformity for this product can be obtained from Xerox.
CE Mark
Figure 1 CE Symbol
The CE mark applied to this product symbolizes Xerox’s
dec
laration of conformity with the following applicable Direc-
tives of the European Union as of the dates indicated:
February 26, 2014: Low Voltage Directive 2014/35/EU
February 26, 2014: Electromagnetic Compatibility Directive 2014/30/EU
April 16, 2014: Radio Equipment Directive 2014/53/EU
To Next Page
Loading...
Need help?
General
Weight and Dimensions
