Xerox B210 - REP 4.9 Registration Roll

July 2019
4-20
Xerox® B210 Service Manual
REP 4.9
Initial Release
Repairs - Adjustments
REP 4.9 Registration Roll
Parts List on PL 4.4
Removal
1. Switch Off the Printer and unplug the Power Cord.
2. Remove the Top Cover, RE
P 3.2.
3. Remove the Bottom Bar and Duplex Assembly, REP 4.6.
4. Remove the Fuser Module, REP 4.6.
5. Remove the Main Drive Unit, REP 4.17.
6. Remove the Feed and Registration Clutches, REP 4.3.
7. Remove the Feed and Registration Clutch Drive Gears, Figure 1.
Figure 1 Feed and Registration Clutch Drive Gears
8. Remove the feed and registration drive gears and bushings, F
igure 2:
NOTE: Make note of the order the feed and registration drive gears are removed for re-
installation.
a. Remove the snap-ring, then remove the feed and registration drive gears.
b. Remove two snap-rings, then remove then feed and registration clutch bushings.
c. Release two latches, then remove the shaft bushings.
Figure 2 Drive Gears and Bushings
Clutch Drive
Gears
Snap Ring
Feed & Registration Drive Gears
Clutch Bushings
Shaft Bushings