Initial Setup
− Engine: Version information for the engine software installed on your printer.
− Network: Version information for the networking software installed on your printer.
6. Under Page Description Language, view the version information for the PCL, PostScript, and PDF
software installed on your printer.
7. Under Memory, view the RAM size and RAM disk of the printer. The RAM Disk function is available
only on printers without an optional SD memory card installed.
Cloning Printer Settings
You can use cloning to copy configuration settings from one printer to another printer on the same
network. To use the clone feature, both the source printer and the destination printer must be the same
model and have the same version of firmware.
Note: Before you copy the address book, verify that the address book of the target printer is empty.
To clone the printer settings:
1. From the General Setup menu, click Cloning.
2. Select the parameters to clone from this printer:
a. To clone the settings from this printer, select Printer Settings.
b. To clone the contact information from the address book, select Address Book.
3. To use the password for the destination printer, under Enter IP Address of Destination Printer, select
Use the printer's password.
4. In the IP Address field, enter the IP address of the destination printer.
5. If you selected Use the printer's password, in the Password field, enter the password for the
destination printer.
6. Click Clone Selected Settings.
26 Xerox
®
WorkCentre
®
3615 Black and White Multifunction Printer
System Administrator Guide
To Next Page
Loading...
Need help?
General
