Xerox WorkCentre 3615 System Administrator Guide

Network Connectivity
Configuring SNMPv1/v2c
SNMP is a network management protocol. SNMP version 1 (SNMPv1) is the first implementation of the
SNMP protocol. It operates over protocols including UDP, IP, and IPX.
SNMP version 2 (SNMPv2c) includes improvements in performance, confidentiality, and
manager-to-manager communications over SNMPv1, however it uses the simple-community based
security scheme of SNMPv1.
1. At your computer, open a Web browser, in the address field, type the IP address of the printer, then
press Enter or Return.
Note: If you do not know the IP address of your printer, see Finding the IP Address of Your Printer on
page 12.
2. Click Properties > Protocols > SNMP > Edit SNMPv1/v2c Properties.
3. For GET Community Name, type a name.
4. To allow a host with this community name to perform SNMP SETS on the printer, for SET
Community Name, type a name.
5. To allow a host with this community name to receive traps from printer, for Trap Community Name,
type a name.
6. For up to four configurations, do the following:
a. For Trap Address Type, select an option.
b. For Trap Destination Address, type an IP address. IPv4 address format is x.x.x.x, where x
represents a decimal number from 0 through 255. Ensure that the value entered is a valid
address and does not start with 127 or a number from 224 through 254. IPv6 addresses
contain hexadecimal digits delimited by the colon (:) character, and can be up to 39 characters
in length.
c. For Port Number, type a number from 0 through 65535.
d. To send notifications to specified addresses, for Notify, select the trap types.
7. To enable authentication traps, for Authentication Error Trap, select Enabled.
8. Click Save Changes.
Configuring SNMPv3
SNMPv3 is the current standard version of SNMP defined by the Internet Engineering Task Force (IETF).
It provides three important security features:
• Message integrity to ensure that a packet has not been tampered with in transit
• Authentication to verify that the message is from a valid source
• Encryption of packets to prevent unauthorized access
50 Xerox
®
WorkCentre
®
3615 Black and White Multifunction Printer
System Administrator Guide

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux