Xerox WorkCentre M20 - Page 144

December 2006
4-46
WorkCentre M20, 4118, FaxCentre 2218 Family
REP 8.6
Repairs and Adjustments
4. Remove the MEA unit guide CST PA assembly, Figure 2.
Figure 2 MEA unit guide CST PA assembly removal
5. Remove the solenoid pickup and gear - pickup, Figure 3.
Figure 3 Solenoid and gear pickup removal
CAUTION
Do not damage the IPR GND input when removing the ELA HOU pickup plus assembly.
1
Remove 2 screws, then
the MEA unit guide CST
PA assembly.
1
Remove 2 screws, then
the solenoid pickup.
2
Remove the gear
pickup.
3
Carefully push a 2mm allen
key (or similar tool) into the
hole to release the bearing.
4
While the bearing is released,
rotate it 90 degrees to align the
clips with the cutouts in the
machine frame. Slide the bearing
forward to remove.