B95W
Description
05_Beschreibung_en.fm - V1.0 - 1.8.17
107 / 306
5
11
Setting up a new key
A new key is taught in with a master key that is identified with a red key pommel.
The master key must be stored carefully; only one master key is available for
each immobilizer.
This master key can only be used to set up new keys; it cannot be used to
deactivate the immobilizer. This prevents the master key from being used to
operate the vehicle.
Insert the master key into the ignition lock.
Set the master key to position “1” (terminal 15 on) for max. of 5 seconds.
Set the master key to position “0” (terminal 15 off).
Pull out the master key.
J The immobilizer system expects the new key to be inserted within 15 seconds.
Insert the new key into the ignition lock.
Turn the key to position “1”.
J The key is registered as a valid key.
If no key is recognized within 15 seconds, the new-key procedure ends
automatically.
Setting up multiple new keys
Insert the new keys into the ignition lock one after the other.
Turn the key to position “1”.
Leave the individual keys in position “1” for at least 1 second.
Up to 10 keys can be set up.
With this technique, it is possible to add one key for several immobilizers, such
as for a general fleet key.
Delete new keys
Deleting keys is necessary if the key has been lost.
Notice
This function is only available if the control unit relay is additionally
connected to terminal 30.
To Next Page
Loading...
