B95W
Description
108 / 306
5
05_Beschreibung_en.fm - V1.0 - 1.8.17
11
All keys are cleared during the deletion process. After clearing, all available keys
can be set up again.
Insert the master key into the ignition lock.
Set the master key to position “1” (terminal 15 on) for minimum 20 seconds.
All keys are cleared and all available keys can be set up again.
The master key code is not deleted during the clearing process.
Security functions
If more than 5 keys are activated in the ignition lock within 1 minute with different
invalid codes, the immobilizer remains active for 15 minutes and accepts no
valid keys during this time.
This procedure prevents the “testing” of different keys so that the correct key
cannot be identified through trial and error.
If different invalid keys are detected without the ignition lock being brought to
position “0”, the immobilizer remains activated for 15 minutes and accepts no
valid keys.
Valid keys are only accepted once the 15 minutes have elapsed and the start
switch is detected in the “0” position. This prevents the key from being tested
without the mechanical ignition lock being activated, e.g. by forcing the ignition
lock into position “1”.
Malfunctioning
Information about malfunctions: See chapter 10.3.2 “Immobilizer Malfunctions”.
Notice
This function is only available if the control unit relay is additionally
connected to terminal 30.
To Next Page
Loading...
