B95W
Maintenance
06_Wartung und Pflege_en.fm - V1.0 - 1.8.17
139 / 306
6
20
Cleaning the cooling fins
Clean the combination cooler by blowing it out with compressed air from the
air discharge side.
If necessary, e. g. in if the cooler is contaminated with oil, clean it with cold
cleansing agent or steam cleaning equipment.
J For this work, park the machine on a washing area equipped with an oil
separator.
After cleaning, run the engine until it reaches the operating temperature so
that it can dry the water cooler.
Reversing fan
(option)
Use the reversing fan of the engine to remove any foliage or the like from the
cooler.
J See chapter “Submenu, fan control”.
Risk of machine damage
If the machine is cleaned while hot or while the engine is
running, there is a risk of damage. Exposure to high
pressure during cleaning can damage the cooler.
Z Only perform cleaning after stopping the engine and letting
it cool down.
Z Maintain an adequate distance during cleaning.
Risk posed by overheating
A dirty cooler can cause the engine/hydraulic system to
overheat and result in serious damage to the machine.
Z Clean the cooler carefully.
Danger posed by dislodged parts
Air cleaning with compressed air can dislodge parts and
result in eye injuries.
Z Wear personal protective equipment.
Risk posed by hot / moving machine parts
Machine parts may move while the machine is running.
Fluids/machine parts may remain hot even after the
machine has been parked. Danger of crushing and burns.
Z Only perform cleaning after stopping the engine and letting
it cool down.
To Next Page
Loading...
