B95W
Maintenance
06_Wartung und Pflege_en.fm - V1.0 - 1.8.17
155 / 306
6
20
Changing the
fuel pre-filter
element
Shut down the engine.
Shut off the fuel supply to the engine (with tank elevated).
Detach the cable (5)
Attach a hose to the drain plug (6) and feed it into a container.
Open the drain plug (6) and drain the fluid.
Unscrew the filter insert (7).
Clean the sealing surface of the new filter element and the opposite side of
the filter head.
Moisten the sealing surface of the filter element (7) slightly with fuel.
Install the filter element in a clockwise direction. Tighten it to a torque of
17-18 Nm.
Fit the drain plug (6).
Torque: 1.6 ± 0.3 Nm
Attach the cable (5).
Open the fuel shut-off valve and vent the system.
J See chapter “Bleeding the fuel system”.
Start the engine.
After starting the engine, check the system for leaks.
To Next Page
Loading...
